News

End-fed half wave antennas.

All our antennas have been set up on the bench and fully tested in the field with high power RF to ensure everyone reaches our customers working right out of the box.

Single-Band Antennas.

The single band antennas use an air wound coil and a coax stub capacitor for increased power handling.

This is a tuned LC circuit which is very efficient, do not attempt to use on any other band other than the one it was designed for.

You could damage the antenna and also your transceiver.

Expect a SWR< 1:1.5 across the band it covers.

Multi-Band Antennas.

The multi band antenna uses a 49:1 transformer to convert the high impedance down to 50 Ohm for your transceiver.

The quad band 40/20/15/ and 10m antenna is a full half-wave on 40m all odd and even harmonics above 40m will resonate to give you multi band capability.

The seven band 80/40/20/17/15/12 and 10m antenna is a full half wave on 80m, some call this an eight band and include the 30m band, you will need an ATU for this band, SWR will be between 2.5 to 3.0

Expect a SWR< 1:1.5 across the bands it covers ( an atu may be needed on some bands on band edge’s)

Stock.

If an item is not in stock just get in touch, even if its a design not listed we might be able to help.

At busy times stock will be low, we are a small family business.

SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE TO IMPROVE RELIABILITY, PERFORMANCE, FUNCTION OR DESIGN.

Leave a Reply

Your email address will not be published. Required fields are marked *